How to Unlock the Overdesign IV Trophy in Black Flag resynced

What Is the Overdesign IV Trophy?

Overdesign IV is one of the more specific trophies in Black Flag resynced.

To unlock it, you need to complete a short combat sequence near a ship railing using a smoke bomb, a berserk dart, and a takedown.

It sounds awkward at first, but it becomes simple once you know the order.

Best Place to Try It

A ship deck is the best place to attempt this trophy.

You want a group of enemies standing close enough together, with at least one enemy near a railing.

That gives you room to drop the smoke bomb, use the blowpipe, and then knock an enemy into the railing for the final part of the sequence.

Start With a Smoke Bomb

Begin by getting close to a small group of enemies near the railing.

Press Down on the D-pad to drop a smoke bomb. This stuns the enemies and gives you a safer setup for the next step.

Try to stay close after dropping the smoke bomb so you can continue the sequence without losing the group.

Shoot a Berserk Dart

Next, use your blowpipe and make sure berserk darts are selected, not sleep darts.

Hold L2 and switch dart types if needed, then shoot a berserk dart into one of the enemies inside the smoke.

Using the wrong dart type can ruin the attempt, so double-check before firing.

Kick the Enemy Into the Railing

After the smoke bomb and berserk dart, move into position beside an enemy near the railing.

Use R2 + Square to kick the enemy into the railing, then follow through with the takedown.

If the positioning is right, the enemy should go over the railing and complete the final part of the sequence.

Trophy Unlocked

If the full sequence is done correctly, the Overdesign IV trophy should unlock immediately.

If it does not pop, the usual problem is positioning or doing the actions out of order.

Quick Tips

• Try it on a ship where enemies stand close to railings.
• Drop the smoke bomb first.
• Make sure you shoot a berserk dart, not a sleep dart.
• Line up the enemy properly before using the kick and takedown.
• If it fails, reset and do the full sequence again in the correct order.

Once you know the setup, Overdesign IV is much easier than it first looks.